Stainless Steel Handmade Sink Manufacturers Introducing The Installation Steps For The Sink
In the kitchen decoration, the sink occupies a high position, so how to make the sink can be saved in the future, then you need to pay attention to some details when installing the sink, followed by Stainless Steel Handmade Sink Manufacturers Let’s take a look.
1. Cutting position Generally, the sinks are installed on the counter tops. Now the cabinets can be customized. Only the specifications of the sinks will be opened by the merchants.
2. Before installing and installing the sink, the corresponding accessories should be installed. When installing the faucet, not only the installation is required to be firm, but also the water penetration at the joint is not allowed to prevent the rust and rot. The combination of the water outlet must be installed correctly, especially the position of the rubber ring.
3. Place the sink After installing some functional accessories of the sink, you can place the sink to the corresponding position of the previously cut table, and prepare to start the next installation procedure.
4. Start installing and installing the inlet pipe of the faucet. Connect one end of the inlet pipe installed on the faucet to the inlet switch. Pay attention to the firmness of the connection when installing. Do not be too tight or too loose. At the same time, pay attention to one detail. The location of the hot and cold water pipes should be left hot and cold right. Many households do not follow the specifications, resulting in the opposite direction of temperature adjustment of the faucet handle switch when using water.
5. The overflow pipe overflow hole for installing the overflow hole is a protection hole for avoiding the overflow of the water tank. Therefore, when installing the water pipe under the overflow hole, pay attention to the sealing property of the joint with the tank body, and ensure that the water pipe of the overflow hole itself No water leakage.
6, the installation of the overall drain pipe usually people will buy a double-slot sink, but the distance between the two downpipes is close, but you do not have to worry, the current business will calculate the size of the downpipe, we just press Prompt to install.
7. Installation and finishing, after the drainage test is completed. After the basic installation is completed, the filter basket is also installed, and the next experiment is started. When doing the drainage test, it is necessary to fill the water tank with water and test the drainage of the double tank drain and the overflow hole. When draining, if there is any phenomenon of water seepage, rework immediately, and then fasten the cap or glue to ensure that it will not be used in the future. Note that it is necessary to test the water and find that there is no water leakage.
8. After the drainage test is completed around the sealing body, ensure that there is no problem, the sink can be sealed. When sealing with glass glue, make sure that the gap between the water tank and the table top is even and there is no water seepage.
information about Stainless Steel Handmade Sink Manufacturers : https://www.afastainlesskb.com/product/sink/handmade-sink/