Handmade Sink Manufacturers Share The Thickness Of The General Sink
If the manual sink has 4mm thicker, is this sink better than a 1.2mm manual sink or a one-piece stretch stainless steel sink? Is it necessary to choose 4mm when you want to buy? Today, Afa handmade sink manufacturers will come to explore.
At present, most of the water tanks on the market are between 0.8 and 1.2 mm. The one-piece drawing water tank is stretched by a stainless steel plate with a thickness of 1.2 or 1.0 mm, and then annealed and shaped, so that the integrally stretched water tank is thin and uneven. All of this is the case. This is not a disadvantage. It is determined by the nature of the process of stretching the sink. There may be some places of 0.8, some places are 0.9, and some places are 1.0. Generally, the thickness of the one-piece stretch tank is too thick, and the press machine is incapable. After all, it requires sufficient pressure to stretch the steel plate, so the one-piece stretch tank is absolutely not 4 mm.
The 4mm stretching trough is definitely not available. Basically, 100% are hand-made sinks. Because the manual sink trough is welded, it is not difficult to weld the 4mm sink. The 1cm steel plate can also be used. The 4mm manual sink also includes two types. One is that the whole body includes the groove body with a thickness of 4 mm, and the other is that the edge is 4 mm thick and the groove body is between 1-2 mm.
If the whole tank including the tank is 4mm is not necessary, there are two main reasons:
First: The 1.0mm thick sink is enough to be used until the next renovation will not be bad unless it is vandalized. 4mm undoubtedly increases the cost of production, not as good as this cost is used in other configurations of the sink.
Second: the elasticity of the 4.0mm thick water tank wall is too far from the elasticity of the 1.0mm thick water tank, so there is no benefit to the bowl and the sink body.
information about handmade sink manufacturers : https://www.afastainlesskb.com/product/sink/handmade-sink/